setup. hold. optimizations. transistor level questions. timing circuits
Physical Design Interview Questions
711 physical design interview questions shared by candidates
voltages across capacitors and resistors mix circuits
What is negative slack Does setup and hold occur in a single cycle Briefly explain place and route flow How to you efficiently build the clock tree
modulo 3 and xor in wave form
The question was about the placement of flops during routing. The interviewer asked me if there is a wire or an interconnect where exactly would I want to place a flip flop into the design-At the start, in the middle or the end. She gave X, Y locations and wanted me to identify where I would be placing the flops to stabilize the design.
Nothing unexpected they ask only valid questions at least which are required for them
PNR flow and basics of PD
Describe you project at school
How does it take to the principal of the role of engineering and technology in the world of the role
How to fix IR-drop and EM violations?
Viewing 561 - 570 interview questions