Apply KVL and determine the output voltages in the circuit. (Circuits were like RL or RC circuits or modified Op-amp circuits, NMOS, and PMOS circuits)
Analog Engineer Interview Questions
986 analog engineer interview questions shared by candidates
what are your future aspects ?
Project Oriented, basic knowledge about network analysis, Conceptual questions like diode is replaced these were asked
To explain the use of components in one circuit
In technical they asked about low pass filter and high pass filter,their characteristics. some question were asked related to my projects.
I was first asked about my internship-projects/papers and asked to explain the work in detail.
When you fail the project how did you overcome? explain
Basic RC ckt something explain
By attaching a camera to the hand of the user and a visual marker to each finger tip, they use computer vision techniques to estimate the relative position of the finger tips. Once they have information about the tips, they apply inverse kinematics techniques in order to estimate the position of each finger joint and recreate the movements of the fingers of the user in a virtual world.[5] Adding a motion tracker device, one can also map pitch, yaw, roll and XYZ-translations of the hand of the user, (almost) recreating all the gesture and posture performed by the hand of the user in a low cost device.
How NAND gate can be implemented through CMOS?
Viewing 611 - 620 interview questions